I prepped the figure in the usual way; soaking it in a dish of water with a couple drops of dish- soap added, then giving it a light scrub with a soft toothbrush, and then rinsing and drying. I then glued the figure to a 2" brown-primed (It was brown because it was left over from another project and was the only washer I had on hand that would fit this large figure.) fender washer with Aleene's Tacky glue. I didn't need to glue the washer to a tongue depressor as it was big enough to hold easily in my hand while painting.
I began by giving the whole figure a wash with Iron Wind Metals "Deep Turquoise" ink applied liberally with a very wet brush.
When the ink was dry, I drybrushed the entire figure with Americana "Salem Blue".
I then dry brushed the figure with White, trying mainly to hit the edges and tips of the waves.
After the figure had overnight to dry, I gave it a coat of Americana "DuraClear Gloss" Varnish. When this was dry, I flocked the base. I let the flock dry, and then I painted some of the DuraClear Gloss" Varnish on the flock immediately around the figure to give the impression of a wet area on the ground around the elemental.
I'm really pleased with how this figure turned out. I think the watery look really comes across.
Nice sculpt and coloring job, sir.
ReplyDeleteThank you. I agree that the sculpt really captures the dynamic movement of water.
DeleteVery nice. That's easily on par with the Pathfinder Battles one from a few years ago, and so few steps for such nice results. It's crazy how much that ink shifted the color of the model.
ReplyDeleteThank you. I really put a lot of the ink on and it is a nice deep green-blue. It made the perfect deep water color.
DeleteHi Chris
ReplyDeleteDo you do commissions ?
Like, if i sent the same water elemental your way, will you paint it the same way for a fee ?
Jonathan- thanks for the offer; I'm flattered. But I barely have enough time to paint my own minis, and a huge backlog to boot. So I'm going to have to say no.
DeleteHi Chris, Did you prime your mini at all?
ReplyDeleteI am unable to get Vallejo paint or ink to adhere to the surface at all.
I primed a few when I first started painting them, but I haven't primed my Bones the last couple years. I have found the key for me is to let them soak overnight in a dish of water with a few drops of liquid dish detergent added to it. Then give them a scrub with a soft toothbrush, rinse, and let them dry. I also like to give some a pre-coat of thinned Reaper Liner; but that is more to help me see the details on the stark white figure than it is to serve as any true primer. I highly recommend this article on the Reaper Forum for a comprehensive look at prepping Bones for painting: http://forum.reapermini.com/index.php?/topic/48669-bones-the-first-coat-is-the-difference/
Delete